Chandelier Earrings Jewelry Making Project made with WigJig Tools, Glass Beads, Wire, and Jewelry Supplies

Step 1: Begin this jewelry making project by cutting two three inch pieces of 20 gauge jewelry wire. Cut another segment of 20G wire 1 1/2 inches long. If available, 1/2 hard wire works best.

Step 2: Make a loop in one end of each piece of wire. Straighten all three pieces of wire.

Step 3: Position two pegs in your jig as shown at right. Place the loop in one of the 3 inch segments of wire on the left most peg. Wrap your wire round the second peg as shown above right.

Wire Chandelier Earrings Jewelry Making Project step 3 made with WigJig tools, and jewelry supplies.
Step 3

The WigJig Cyclops or Electra jewelry making jigs are preferred for this pattern, but the pattern can be made on any WigJig. If you use a WigJig Delphi, Olympus or Olympus-Lite you will need to position the pegs in a row separated by about 1/4 inch.

Step 4: Add another peg and wrap your wire around this peg.

Step 5: Add another peg and wrap your wire around this peg.

Step 6: Repeat for the final peg and loop. When completed the wire should appear as shown below, right.