Chandelier Earrings Jewelry Making Project made with WigJig Tools, Glass Beads, Wire, and Jewelry Supplies

Step 14: Remove this wire and beaded component from your jewelry making jig and cut the excess wire. Close the final loop. At this point this wire component should appear as shown at right.	Step 14

Step 15: Now using the same technique that you used in step 12, convert both the initial and final loops into eye loops. See the piece, below, left.

Step 16: At this point we have three wire components and we need to begin assembling the components. Begin with the V shaped wire component. Open both loops in this component. Be sure to open both loops in the same direction as the next step is to add the initial wire component we made to both these loops. Connect this initial wire component as shown below center and close both loops in the V shaped component. This will require a little patience, but not a lot of force. Gently persuade the wire to cooperate.

Step 17: Now add the beaded wire component that we completed in step 15 by opening both loops in that component and connecting it to the V shaped component. Once it is in place, close both loops. The earring body should now appear as shown below, right.