Page 11      Flemish Spiral Earrings Jewelry Making Project

Alternative Design Continued:

Step 15:  Now we need to add the clasp to the end of this side of the necklace.  If you have 4mm beads, use a wrapped bead link with a 4mm bead to connect the commercial chain to the clasp.  If you only have 6mm beads, use that.  This will complete one side of the necklace. 

Step 16:  Repeat the above steps to complete the other side of the necklace.

Step 17:  Now we need to connect the watch to the large Flemish Spiral in the center of the necklace.  In the necklace shown at right, two wrapped bead links were used to connect the pendant watch to the bottom loop in the center Flemish Spiral wire component.  Use 4mm beads for these wrapped bead links if you have them, if not, use 6mm beads. 

The following web page will list the supplies used in making the necklace shown at right.