Classic Pearl Beaded Necklace and Bracelet Jewelry Making Project made with WigJig Tools, Glass Beads, Wire, and Jewelry Supplies

One of the most classic jewelry items is a string of pearls. Historically, pearls were strung on silk thread in a color of silk that matched the shade of the pearls. Between each pearl in the strand was a knot in the silk thread. This made it rather time consuming to make an 18 inch strand of pearls. The reason for the knot was simple. The silk thread breaks. With the newer bead stringing wire, you can avoid the problem of breakage. Now the question is how to you retain the classic separation between the pearls? In this project we will show how to string pearls on Soft Touch, the newest and most flexible bead stringing wire and yet retain the classic look of pearls. We will also make a clasp for our necklace using our WigJig tools.

Pearl Necklace

In the past, one tried to minimize contact between pearls and any metal because usually the metal was harder than the pearls and over time would erode the pearls. With these new Swarovski Crystal Pearls, we can allow metal to touch the "crystal pearl" without worrying about destroying the glass pearls.

Jewelry Making Supplies:

Swarovski Crystal Pearl Beads Bracelet Jewelry Making Project made with WigJig jewelry supplies and beads.
Pearl Bracelet

Jewelry Tools Required:

6 inches of 18G wire preferably 1/2 hard (necklace)
4 inches of 22 or 24G wire preferably 1/2 hard (necklace)
60 6mm Swarovski Crystal Pearls (necklace) (24 for bracelet)
60 1mm Crimp Beads (necklace) (24 for bracelet)
2 2x2mm crimp beads (both)
One commercial clasp (Bracelet)
2.5 inches fine chain (bracelet)

Round Nose Pliers
Flush Cutter
Soft Flex Cutter
Chain Nose or Bent Chain Nose Pliers (2)
Any WigJig acrylic jig
2 metal pegs and two 3/16" Super Pegs
Bead Crimping Pliers
30 minutes of free time