WigJig Jewelry Making Tools Pg 02 for Use with Beads, Wire and Jewelry Supplies

The jewelry making pieces shown at right made in brass wire were made on the WigJig Electra, while the pieces made in purple wire were made on the WigJig Cyclops. The peg pattern used to make these pieces is shown below left for the Electra and below right for the Cyclops.

Electra	Cyclops

For the Christmas tree wire component shown above, it should be obvious that the Cyclops makes smaller and more delicate patterns and the Electra makes larger and bolder patterns. The Electra uses the same 3/32" pegs that were used with the Olympus and Olympus-Lite. The Cyclops uses the smaller 1/16" pegs that are used with the Delphi.

With both of the jewelry making jigs shown above, this pattern could be made larger by spacing the pegs further apart, or could be made at different angles rather than the 60 degree angle chosen here.

Neither the Electra nor the Cyclops can make patterns like the pattern shown for the Delphi and Olympus with parallel rows of pegs.

The general conclusion is for smaller and more delicate components requiring angles other than 45 degrees or 90 degrees choose a WigJig Cyclops. For larger and bolder components requiring angles other than 45 degrees or 90 degrees choose a WigJig Electra.